Found new hardware

LEONARD, I know what you are going through. I have a
3820 and a 2210PSC hooked up. What a nightmare sometimes.
I see you have the 2200 series. This is the most
difficult to recover after a crash. Now, listen close
because the machine has NO margin for error. I'll give
you my routine:
Pull the circuit breaker for your whole unit. Now, and I
hope you have the setup instructions at hand, because
this unit requires a full-dead startup. Follow everything
to a T.
If it still persist, go into ADD/REMOVE and take it out,
leave all connections and your unit will say NEW HAEDWARE
FOUND. Now, load the CD and it will walk you through.
I hope have been of help
>-----Original Message-----
>Hi,
>
>I have a new PC which runs XP. My printer is a HP
Busienss Inkjet 2280 and
>it is connected via parallel port. Each time my PC
boots, it comes up with
>'Found new hardware' message. I have downloaded the
updated driver, but I
>can't get over this problem.
>
>Any ideas would be greatly appreciated.
>
>L.
>
>
>.
>