JayTee
December 7th 03, 09:48 AM
Whenever I try to connect my Pfaff 7570 sewing machine to
the computer and access the memory design card inside it,
with my PCDesigner software I cannot get a connection!
I get an error code as follows:
"this device is disabled because the firmware of the
device did not give it the required resources ICode 29)."
How can I fix this problem? I have contacted Pfaff and
they have admitted they have a problem with this
software, which is no longer manufactured. It worked
once, and no longer does!! Apparently there is no fix on
Pfaff's end. This means that a program of over $1000 no
longer works!
I can't check the BIOS on XP because it doesn't allow
it. What to do???
/jat/
the computer and access the memory design card inside it,
with my PCDesigner software I cannot get a connection!
I get an error code as follows:
"this device is disabled because the firmware of the
device did not give it the required resources ICode 29)."
How can I fix this problem? I have contacted Pfaff and
they have admitted they have a problem with this
software, which is no longer manufactured. It worked
once, and no longer does!! Apparently there is no fix on
Pfaff's end. This means that a program of over $1000 no
longer works!
I can't check the BIOS on XP because it doesn't allow
it. What to do???
/jat/