Walt Mather
December 8th 03, 09:48 PM
I have Acad '04 installed and when I first hooked up the 430 and the "found
new hardware" wizard installed it, I got the "not signed.....by XP"
message. I chose "continue anyway" and it seems ok. However on occasion I
also use the plotter on another (Acad R-12 Dos) system by just switching the
parallel cable. When I re-hook to the XP system, I again get the "found
new hardware" message and have to reinstall. Is there a way to avoid this ?
And is there a reason I get this not supported by XP message ? I'm using
the latest (4.62) driver which is supposed to be for XP.
Thanks, Walt
new hardware" wizard installed it, I got the "not signed.....by XP"
message. I chose "continue anyway" and it seems ok. However on occasion I
also use the plotter on another (Acad R-12 Dos) system by just switching the
parallel cable. When I re-hook to the XP system, I again get the "found
new hardware" message and have to reinstall. Is there a way to avoid this ?
And is there a reason I get this not supported by XP message ? I'm using
the latest (4.62) driver which is supposed to be for XP.
Thanks, Walt