Ian
December 8th 03, 10:01 PM
I have Gigabyte Board with Serial ATA on Board. I want to
boot from ATA drive and have achieved this by mapping the
sata as IDE1. Problem is the system (XP) doesn't reconise
the other IDE, Primary Slave.I also notice that there is
no hardware shown for the SATA drive or Bus ? any clues
boot from ATA drive and have achieved this by mapping the
sata as IDE1. Problem is the system (XP) doesn't reconise
the other IDE, Primary Slave.I also notice that there is
no hardware shown for the SATA drive or Bus ? any clues