I upgraded my Mobo and now I get an error message

[J Pack]

I just upgraded my motherboard and now when I boot, my
system hangs in a blank screen for a couple of minutes
then gives me the following error message:

Windows could not start because of the following ARC
firmware boot configuration problem :
did not properly generate ARC name for HAL and system
paths. Please check the Windows documentation about ARC
configuration options and your hardware reference manuals
for additional information.

[Alvin A Brown]

Hello

Did you do the following below

Do a repair install
http://support.microsoft.com/default.aspx?scid=KB;EN-US;Q315341&ID=KB;EN-US;Q315341



Alvin


J Pack wrote:

> I just upgraded my motherboard and now when I boot, my
> system hangs in a blank screen for a couple of minutes
> then gives me the following error message:
>
> Windows could not start because of the following ARC
> firmware boot configuration problem :
> did not properly generate ARC name for HAL and system
> paths. Please check the Windows documentation about ARC
> configuration options and your hardware reference manuals
> for additional information.

[Bruce Chambers]

Greetings --

Unless the new motherboard is virtually identical to the old one
(same chipset, same IDE controllers, same BIOS version, etc.), you'll
need to perform a repair (a.k.a. in-place upgrade) installation, at
the very least:

How to Perform an In-Place Upgrade of Windows XP
http://support.microsoft.com/directory/article.asp?ID=KB;EN-US;Q315341

As always when undertaking such a significant change, back up any
important data before starting.

This will also require re-activation. If it's been more than 120
days since you last activated that specific Product Key, you'll most
likely be able to activate via the internet without problem. If it's
been less, you might have to make a 5 minute phone call.


Bruce Chambers

--
Help us help you:
http://dts-l.org/goodpost.htm
http://www.catb.org/~esr/faqs/smart-questions.html

You can have peace. Or you can have freedom. Don't ever count on
having both at once. -- RAH


"J Pack" > wrote in message
...
> I just upgraded my motherboard and now when I boot, my
> system hangs in a blank screen for a couple of minutes
> then gives me the following error message:
>
> Windows could not start because of the following ARC
> firmware boot configuration problem :
> did not properly generate ARC name for HAL and system
> paths. Please check the Windows documentation about ARC
> configuration options and your hardware reference manuals
> for additional information.