David
December 9th 03, 10:47 AM
Ok, I pulled a Western Digital 80gig drive from an old
Dell that was upgraded. I built a new system and I am
trying to add the hardrive to the system. When it boots
the drive is detected however it does not load the OS. So
I am now trying to install XP Professional since it
recognizes Dynamic disk and it shows the partition as
<Dyanmic Drive> with 0mb available. The drive had 40gb
available before removing it from the old system.
Anysuggestions how to retain the customers information?
Dell that was upgraded. I built a new system and I am
trying to add the hardrive to the system. When it boots
the drive is detected however it does not load the OS. So
I am now trying to install XP Professional since it
recognizes Dynamic disk and it shows the partition as
<Dyanmic Drive> with 0mb available. The drive had 40gb
available before removing it from the old system.
Anysuggestions how to retain the customers information?