PCyr
December 9th 03, 09:50 AM
I recently bought a UPS (because of these darn rolling blackouts - CONSERVE
ENERGY!), and I have a problem changing the alarm settings.
Both the Activate Low Battery Alarm and Activate Critical battery Alarm
sliders will not allow me to selected anything other than 100%. When I move
the slider, it snaps back to 100%. I didn't (as it wasn't required for XP)
install the software that came with it. I don't think the problem is
related to the UPS itself, but if it matters, it's the APC Back-UPS EZ 350.
Thanks.
--
Check out http://www.kellys-korner-xp.com for amazing tweaks and fixes
Member of "Newsgroups are for everyone" (Perdita X. Twitt is a
self-righteous, ruthless, bitchy net-cop too!)
Email address is fake to prevent SPAM.
Real email address is pcyr2000 AT hotmail DOT com
Change the obvious to the obvious.
------------------
ENERGY!), and I have a problem changing the alarm settings.
Both the Activate Low Battery Alarm and Activate Critical battery Alarm
sliders will not allow me to selected anything other than 100%. When I move
the slider, it snaps back to 100%. I didn't (as it wasn't required for XP)
install the software that came with it. I don't think the problem is
related to the UPS itself, but if it matters, it's the APC Back-UPS EZ 350.
Thanks.
--
Check out http://www.kellys-korner-xp.com for amazing tweaks and fixes
Member of "Newsgroups are for everyone" (Perdita X. Twitt is a
self-righteous, ruthless, bitchy net-cop too!)
Email address is fake to prevent SPAM.
Real email address is pcyr2000 AT hotmail DOT com
Change the obvious to the obvious.
------------------