William Goldston
December 9th 03, 01:19 PM
I set jumpers on both hds. Both to Cable select and
to master and Slave. Same problem.
Disk has been formatted.
The computer came with no recovery disks or XP disks.
Has recovery on hard drive.
Hp_Pavilion (C:) HP_Recovery (D:)
Ran Chkdsk on G: Came back ok - found no problem
>-----Original Message-----
> Did you set the jumpers on both hds.Is the hd formated,
> try running solo,w/o current hd(unplug current hd,set
> new to master),install xp cd,boot to cd,recovery,type:
> FORMAT C: /FS:ntfs xp will change it back to G:.
> When format is over,type:EXIT Shutdown computer,reset
> jumpers reconnect current hd,start.You can even have it
> chk the hd,type:CHKDSK C: /p After the format
>>-----Original Message-----
>>Bought a new Maxtor hard drive. Tried to install it to
my
>>HP pavilion 753n running Windows XP Home. Installed
per
>>instruction book but when rebooted, got Found New
>>Hardware Wizard Box:
>>Cannot install this Hardware
>>There was a problem installing this Hardware
>>Maxtor 6Y120PO
>>An error occurred during the installation of the device
>>The specified service does not exist as an installed
>>service
>>Click Finish to close the Wizard.
>>
>>Once I click Finish, When I go to My Computer it shows
>>New Hard drive as DSK2_VOL1 (G:)
>>When I go to Disk Management, shows Disk 1 Basic Online
>>Healthy (Active)
>>The only place that shows any problem is Device Manager-
>>properties show "The drivers for this device are not
>>installed. (Code 28)
>>I can copy files to and from the new disk.
>>
>>Maxblast Software that came with the new drive, will
not
>>run- says no Maxtor drive found on system.
>>
>>I have been emailing Hp and Maxtor for more than a
week,
>>with no help. Maxtor says there is no driver on their
>>disks because drivers are already on system.
>>
>>I have a older pavilion running Windows ME and the hard
>>drive installed on it great. I tried the drive from it,
>>Quantum Fireball drive, and it does the same on the
753n.
>>
>>All updates from Microsoft have been installed.
>>
>>Thank you for any help you can give me. I have tried
>>everything I can think of and nothing has helped.
>>
>>Bill
>>.
>>
>.
>
to master and Slave. Same problem.
Disk has been formatted.
The computer came with no recovery disks or XP disks.
Has recovery on hard drive.
Hp_Pavilion (C:) HP_Recovery (D:)
Ran Chkdsk on G: Came back ok - found no problem
>-----Original Message-----
> Did you set the jumpers on both hds.Is the hd formated,
> try running solo,w/o current hd(unplug current hd,set
> new to master),install xp cd,boot to cd,recovery,type:
> FORMAT C: /FS:ntfs xp will change it back to G:.
> When format is over,type:EXIT Shutdown computer,reset
> jumpers reconnect current hd,start.You can even have it
> chk the hd,type:CHKDSK C: /p After the format
>>-----Original Message-----
>>Bought a new Maxtor hard drive. Tried to install it to
my
>>HP pavilion 753n running Windows XP Home. Installed
per
>>instruction book but when rebooted, got Found New
>>Hardware Wizard Box:
>>Cannot install this Hardware
>>There was a problem installing this Hardware
>>Maxtor 6Y120PO
>>An error occurred during the installation of the device
>>The specified service does not exist as an installed
>>service
>>Click Finish to close the Wizard.
>>
>>Once I click Finish, When I go to My Computer it shows
>>New Hard drive as DSK2_VOL1 (G:)
>>When I go to Disk Management, shows Disk 1 Basic Online
>>Healthy (Active)
>>The only place that shows any problem is Device Manager-
>>properties show "The drivers for this device are not
>>installed. (Code 28)
>>I can copy files to and from the new disk.
>>
>>Maxblast Software that came with the new drive, will
not
>>run- says no Maxtor drive found on system.
>>
>>I have been emailing Hp and Maxtor for more than a
week,
>>with no help. Maxtor says there is no driver on their
>>disks because drivers are already on system.
>>
>>I have a older pavilion running Windows ME and the hard
>>drive installed on it great. I tried the drive from it,
>>Quantum Fireball drive, and it does the same on the
753n.
>>
>>All updates from Microsoft have been installed.
>>
>>Thank you for any help you can give me. I have tried
>>everything I can think of and nothing has helped.
>>
>>Bill
>>.
>>
>.
>