Jeff
December 11th 03, 07:36 AM
This is a common problem that I have seen reported all
over this Board. I have not yet seen a satisfactory
answer. Responses have referred to a System Restore
troubleshooting Knowledge Base article that has not
helped. It has also been advised to reset System Restore
by turning it off, and then restarting. That also has not
been of much help. There must be a more systemic reason
why so many users are receiving the message that the
system cannot be restored to the chosen point even after
going through and adjusting per the Knowledge Base
article. I would appreciate any additional insight that
anyone might be able to offer.
>-----Original Message-----
>When I attempt to use System Restore and choose a restore
>point I get a message that the the system cannot be
>restored to the chosen point,I have tried working back
>from the latest restore point but still get the same
>message.Could anyone enlighten me.Robert
>.
>
over this Board. I have not yet seen a satisfactory
answer. Responses have referred to a System Restore
troubleshooting Knowledge Base article that has not
helped. It has also been advised to reset System Restore
by turning it off, and then restarting. That also has not
been of much help. There must be a more systemic reason
why so many users are receiving the message that the
system cannot be restored to the chosen point even after
going through and adjusting per the Knowledge Base
article. I would appreciate any additional insight that
anyone might be able to offer.
>-----Original Message-----
>When I attempt to use System Restore and choose a restore
>point I get a message that the the system cannot be
>restored to the chosen point,I have tried working back
>from the latest restore point but still get the same
>message.Could anyone enlighten me.Robert
>.
>