Problem with Canon MultiPass F30 printer since upgrading to SP2

[Lou Garden]

Since upgrading to SP2 I have been having problems with my canon MultiPass F30
Printer. The MP service will not start automatically when the system boots
and I get
a microsoft system error. I can start the MP service manually, but it only
run for
about 10-15 minutes then stops.
Is anyone else having similar problems since upgrading to SP2?

[Andre Da Costa]

Check there website for any driver updates.

Andre
"Lou Garden" > wrote in message
...
> Since upgrading to SP2 I have been having problems with my canon MultiPass
> F30
> Printer. The MP service will not start automatically when the system boots
> and I get
> a microsoft system error. I can start the MP service manually, but it only
> run for
> about 10-15 minutes then stops.
> Is anyone else having similar problems since upgrading to SP2?

[Tushar]

SP2's firewall blocks all the ports in the computer..also
blocking the port that computer uses for printer.
You need to open this.

Steps:
Control Panel-> Security Center-> Windows Firewall->Click
on the EXCEPTIONS tab.
Then check the checkbox that says File & Printer Checking.
Apply & OK...also try restarting the computer after this.
OR you need to open the ports manually. And you would like
to call me a fool as I forgot the port that printer uses.
you can open the ports manually in the exceptions itself.

Take care.
Tushar
>-----Original Message-----
>Since upgrading to SP2 I have been having problems with
my canon MultiPass F30
>Printer. The MP service will not start automatically when
the system boots
>and I get
>a microsoft system error. I can start the MP service
manually, but it only
>run for
>about 10-15 minutes then stops.
>Is anyone else having similar problems since upgrading to
SP2?
>.
>