Cannot be found the specified unit
I run the command G: \ \ 172.16.196.2 \ Cart_Cond
where \\172.16.196.2 is the 'WinXP gatway' and Cart_Cond is a shared linux folder to open . I get the error cannot found the unit specified Yet the command okay. I 've done this before! What can be the problem ? Thanks |
Cannot be found the specified unit
On Jul 30, 2:54*am, linus wrote:
I run the command G: \ \ 172.16.196.2 \ Cart_Cond where \\172.16.196.2 is the 'WinXP gatway' and Cart_Cond is a shared linux folder to open . I get *the error cannot found the unit specified Yet the command okay. I 've done this before! What can be the problem ? Thanks Yes the command syntax is sort of OK but you should use the IP address of the Linux computer instead. The gateway, is typically the address to the router/switch. My gateway address is 192.168.0.1. But its just a device, no resurces stored on it. Just a pass through point to tie the computers on the LAN together. dir \\linux-ip-address\Cart_Cond If your create a mapped drive to G: to the Cart_Cond share then you can type the following command to access the share. G: |
All times are GMT +1. The time now is 02:26 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 2004 - 2006 PCbanter
Comments are property of their posters