A Windows XP help forum. PCbanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » PCbanter forum » Search Forums
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Showing results 1 to 18 of 18
Search took 1.44 seconds.
Search: Posts Made By: sheppardwk
Forum: Windows XP Help and Support July 6th 09, 01:24 PM Posted to microsoft.public.windowsxp.help_and_support
Replies: 7
Views: 573
Posted By sheppardwk
BSOD occurring when accessing IE 6

We have not been using any products from global.

I used the Dell Driver Tool and it found no problems with any drivers.

Here are the errors:


System Error:

Event Type: Error
Forum: Windows XP Help and Support July 6th 09, 02:08 AM Posted to microsoft.public.windowsxp.help_and_support
Replies: 7
Views: 573
Posted By sheppardwk
BSOD occurring when accessing IE 6

Just recently, IE 6 has caused the computer to show the BSOD. We have
followed all of the recommendations, uninstalling any new software; however,
no new hardware has been installed. It seems to...
Forum: Windows XP and video cards, drivers and similar June 25th 09, 01:16 PM Posted to microsoft.public.windowsxp.video
Replies: 12
Views: 1,781
Posted By sheppardwk
Video plays then goes blank

I meant the DVI cable that plugs into the monitor - the video cable.
The DVD drive is located in the computer.

I tried to watch a streaming press conference the other day. The video
played for...
Forum: Windows XP and video cards, drivers and similar June 11th 09, 05:09 PM Posted to microsoft.public.windowsxp.video
Replies: 12
Views: 1,781
Posted By sheppardwk
Video plays then goes blank

I used a store bought DVD, and tried to play it in the VLC Player. The DVD
started fine and played perfectly until about 4:10. At that time, the screen
elongated again changing the aspect. About...
Forum: Windows XP and video cards, drivers and similar June 10th 09, 09:09 PM Posted to microsoft.public.windowsxp.video
Replies: 12
Views: 1,781
Posted By sheppardwk
Video plays then goes blank

DVD's used to work on the PC.

I tried to play a DVD using the VLC player, but after 4 minutes the screen
elongated. About a minute later, 1/4 of the desktop was a blue screen with
the player...
Forum: Windows XP and video cards, drivers and similar June 9th 09, 05:22 PM Posted to microsoft.public.windowsxp.video
Replies: 12
Views: 1,781
Posted By sheppardwk
Video plays then goes blank

I just downloaded and installed the VLC player.
Started the avi file and it played for approximately 2 minutes. The screen
resolution then changed - it appeared to elongate vertically. About 2...
Forum: Windows XP and video cards, drivers and similar June 9th 09, 02:51 PM Posted to microsoft.public.windowsxp.video
Replies: 12
Views: 1,781
Posted By sheppardwk
Video plays then goes blank

I was mistaken, I have updated to SP3. I'm using the NVIDIA Quadro FX
3450/4000 SDI and the driver is up-to-date.
Yes, the DVD's work in a standalone player and on other computers.
Mpeg, avi, and...
Forum: Windows XP and video cards, drivers and similar June 8th 09, 07:56 PM Posted to microsoft.public.windowsxp.video
Replies: 12
Views: 1,781
Posted By sheppardwk
Video plays then goes blank

Windows XP SP 2 using WMP 11 to watch a DVD, or a video clip the movie will
play for 30 seconds or so and then the screen goes blank. The audio
continues, but I'm staring at a slightly grey...
Forum: Networking and the Internet with Windows XP October 1st 08, 05:23 PM Posted to microsoft.public.windowsxp.network_web
Replies: 5
Views: 269
Posted By sheppardwk
XP and Windows 98 Network

Using the ipconfig command, I determined that the new ip addresses that the
new router assigned were different than those stored in Zone alarm. Revising
the addresses and identifying them as...
Forum: Networking and the Internet with Windows XP September 30th 08, 04:36 PM Posted to microsoft.public.windowsxp.network_web
Replies: 5
Views: 269
Posted By sheppardwk
XP and Windows 98 Network

Thanks for the link.
Under Zone Alarm's Firewall tab, I have a Mapped Drive entry,
DHCP entry and a Server and Loopback adapter. They are all identified as
"Trusted."
Shouldn't the second computer...
Forum: Networking and the Internet with Windows XP September 29th 08, 10:05 PM Posted to microsoft.public.windowsxp.network_web
Replies: 5
Views: 269
Posted By sheppardwk
XP and Windows 98 Network

Thanks for your response; however, I'm not sure where to start. How do I
tell Zone Alarm to trust the new subnet? How do I establish the new subnet,
because I haven't done anything to Zone Alarm...
Forum: Networking and the Internet with Windows XP September 29th 08, 02:25 AM Posted to microsoft.public.windowsxp.network_web
Replies: 5
Views: 269
Posted By sheppardwk
XP and Windows 98 Network

My Microsoft MN-100 wired router went out this weekend and I replaced it with
a Dynex. I followed the setup instructions and both computers have access to
the internet; however, I can't seem to...
Forum: Windows XP Help and Support July 27th 08, 06:27 PM Posted to microsoft.public.windowsxp.help_and_support
Replies: 7
Views: 367
Posted By sheppardwk
Config.sys error

When I rebooted, the computer went to Windows and then a light blue screen
appeared and the
Checking File on C:
File System is NTFS
Volume is dirty

CHKDSK is verifying files (Stage 1 of 3)
CHKDSK...
Forum: Windows XP Help and Support July 27th 08, 05:00 PM Posted to microsoft.public.windowsxp.help_and_support
Replies: 3
Views: 381
Posted By sheppardwk
XP Repair Problems

I have a three (3) year old Dell that already had Windows XP loaded.
Received the following error message:

Windows XP could not start because the
following file is missing or corrupt:...
Forum: Windows XP Help and Support July 27th 08, 03:21 PM Posted to microsoft.public.windowsxp.help_and_support
Replies: 7
Views: 367
Posted By sheppardwk
Config.sys error

I found the system.bak file in the Repair folder and copied it to the Config
folder. When I rebooted, I received the Blue Screen indicating 0x0000007B.
I then went to the tmp directory where I...
Forum: Windows XP Help and Support July 26th 08, 02:11 AM Posted to microsoft.public.windowsxp.help_and_support
Replies: 7
Views: 367
Posted By sheppardwk
Config.sys error

I tried again and could type all but the first one

copy c:\windows\repair\system c:\windows\system32\config\system

These all worked:
copy c:\windows\repair\software...
Forum: Windows XP Help and Support July 26th 08, 01:44 AM Posted to microsoft.public.windowsxp.help_and_support
Replies: 7
Views: 367
Posted By sheppardwk
Config.sys error

I came home from work and have the Windows XP could not start because the
following file is missing or corrupt: \WINDOWS\SYSTEM32\CONFIG\SYSTEM error.

Went to find help and found...
Forum: Windows XP Help and Support September 22nd 07, 01:40 AM Posted to microsoft.public.windowsxp.help_and_support
Replies: 0
Views: 189
Posted By sheppardwk
Cannot click on user account(s)

Noticed the computer (XP SP2, 3.2 Pentium, 1Gb Ram, 160 Gb HD) was sluggish,
went to Task Manager/Processes and viewed multiple entries of iexplore.exe,
Outlook.exe, etc. Closed some of them and...
Showing results 1 to 18 of 18

 





All times are GMT +1. The time now is 03:01 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 PCbanter.
The comments are property of their posters.