Robert in CA wrote:
I checked my FF

https://postimg.cc/jCXTskMh

I did look at the applications while in Task Mgr to see
if I could see one that was using allot. There were about
7 or 8 FF applications with various sizes. I don't know if
that's normal or not but it seemed odd to me. I'll take pics
next time if it happens again.

This isn't disk #5 its the #4hd, and #3 is inside the computer
If I understand you correctly you want me to put the 1TB
back into the 8500 and try cloning #4?

If it doesn't connect normally do I go into disk management
and if the drive is there then will Macrium detect so we can
clone?

Robert

That's the hope, that with the 1TB drive inside, an enclosure
with #4 outside (a drive with nothing on it right now), you
can clone over. As near as I can determine from here, the entry
at the bottom of Disk Management looked ready to go. You can use
the copy of Macrium on the 1TB drive, to do the clone. (That's because,
it looks like the enclosure is working when the configuration runs
off the 1TB.)

We definitely don't want to erase your MRIMG collection, OK ?
Make sure the destination of the clone, is a disk that has
nothing to lose on it.

Paul