I'm on the 780 at the moment,

I made a System Restore point on the 8500 and did a successful
Mrimg on the 780. I then checked Disk Management to make sure
the HD partition was OK and didn't need resizing. Afterwards I
decided to check #1 and #2 hd partitions but they would not connect
to the 780.

https://postimg.cc/DS1NxtV3
https://postimg.cc/0rq0fbkj
https://postimg.cc/4Yn6dc5L

I thought these were OK and I booted them after cloning. So do I need
to erase the hd's and start over? Do we need to enable the autoplay?
This is so weird. First we had problems with the 780 boot menu and
then all the problems with the 8500 and now this on the 780. I haven't
tested #2hd yet.
Robert