On 03/17/2018 10:30 AM, Mayayana wrote:

[snip]

On the other hand, I can't read the source in TB
unless I save the file out.

What is "save the file out"? Anyway, to view the message source, press
CTRL-U, or use the View menu, "Message Source".

I have to set outgoing
servers in a different place from incoming servers,
which can be very confusing for inexpreienced
people.

Of course I didn't STAY inexperienced too long. Anyway, that one wasn't
hard to figure out.

TB is extremely pushy about wanting me to
use their halfwit "wizard" to set up my accounts...

When they started that wizard, it would mess up for me. It had been much
easier to enter the information manually. The wizard made that a lot
harder. However, the last time I set up TB the wizard worked fine.

There are various small problems with each, but
essentially they're the same thing.

--
Mark Lloyd
http://notstupid.us/

"We have at last ascertained that miracles can be perfectly understood;
that there is nothing mysterious about them; that they are simply
transparent falsehoods." -- Robert Ingersoll