O.T. Cleaning computer
On Fri, 21 Dec 2018 14:35:13 +0000, ? Good Guy ?
wrote:
On 21/12/2018 04:39, DK wrote:
Leaf blower! Needs to be done outside because of all the dust it releases
in the air but leaves the whole case/motherboard/radiator/fans in pristinely
clean condition.
Vacuum is not anywhere as efficient.
Best solution is to use a hose pipe with a pump to wash out everything
in the computer. Alternatively, put the machine in a bath tub to soak
it overnight with a good quality bleach!!!.
Warm water with a bit of dish detergent and de-ionized water for a
rinse, will fix a lot of problems, particularly those that manifest
themselves in high humidity conditions due to crude on the circuit
boards.
BUT it takes a fair amount of electronics knowledge to know which
parts are not sealed and should stay dry, and a good drying technique
is a practical necessity. A home oven will work to warm and drive off
the moisture but a vacuum oven would be a better choice.
The folks that use isopropyl alcohol are essentially using a solvent
with the same characteristics as water. (most of it is ~30% water) It
just evaporates a lot faster than water so is easier to dry.
|