If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Faxing problems
I just CANNOT send or receive a fax. I get as far
as "sending fax" message and the end result is always the same .. "no answer" I have the right nos but I must be doing some wrong. I am using XP with Lexmark73 and all other functions are fine. I have been using the other functions for 8 months now and no problems at all. When I first set up I did succeed in sending Fax so I know nothing is actually wrong. I called Lexmark on their helpline but they are no more informed than I am or at least the person I spoke to. If any help at all I would really appreciate it as I think I have exhausted all avenues by now. |
Ads |
#2
|
|||
|
|||
Faxing problems
I use this FREE Fax software to send/receive faxes from
http://www.v3inc.com/. After downloaded and set up, when you need to fax any docs etc go to fileprintV3 Callcentre printer. You will then be prompted by a wizard to input the appropriate details. The web page says this software does not support ISDN or Cable Modems, it does, I am on Cable Broadband and all I do when needing to send a Fax is re-connect my dial up modem from my computer into phone socket. It seems to work ok. I hope this will/may help to start sending faxes again. If you have any probs re-post here. Chow "Pat" wrote in message ... I just CANNOT send or receive a fax. I get as far as "sending fax" message and the end result is always the same .. "no answer" I have the right nos but I must be doing some wrong. I am using XP with Lexmark73 and all other functions are fine. I have been using the other functions for 8 months now and no problems at all. When I first set up I did succeed in sending Fax so I know nothing is actually wrong. I called Lexmark on their helpline but they are no more informed than I am or at least the person I spoke to. If any help at all I would really appreciate it as I think I have exhausted all avenues by now. |
Thread Tools | |
Display Modes | |
|
|