If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
FujiFilm NX500 installation
I cannot get my computer to regonise this printer. When
the USB is connected it makes a 'double' noise rather than the 'single' noise it usually makes when hardware is connected. I have the correct driver to install the printer but as the computer does not recognise that the printer is connected I am not getting very far. Has any one got any ideas? |
Ads |
Thread Tools | |
Display Modes | |
|
|