If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can't get XP SP2 to install
When trying to install SP2, I get the following message:
Not enough dik space on C:\WINDOWS\$NtServicePackUninstall$ to install Service Pack2. Setup requires a minimum of 1 additional MB of free space or if you also want to archive the fales for uninstallation, Setup requires 1 additional MB of free space. Free additional space on your hard disk and try again. I have 8GB of free space on my hard drive. Is this not enough? I've installed it on a computer that had much less. Can anyone tell me how to get around this? Thanks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can't boot after xp sp2 install | Hass | Windows Service Pack 2 | 2 | August 30th 05 08:27 AM |
SP2 Install Hangs at 'Finishing Installation' | Richard Boatfield | Windows Service Pack 2 | 2 | February 1st 05 10:24 AM |
SP2 64 bit version? | Rob | Windows Service Pack 2 | 14 | December 8th 04 12:03 PM |
Not "burning" to Cd after SP2 upgrade | \old\ devildog | Windows Service Pack 2 | 4 | December 2nd 04 05:33 PM |
SP2 Boot failure, system freeze, AGPCPQ.SYS, AGP440.SYS lock-ups. | Trebor | Windows Service Pack 2 | 2 | October 19th 04 07:55 PM |