Page_Fault_in_Nonpaged_Area

To give some history:
I got an error after doing a restoration of an Image created by Acronis True
Image. But the original error was: "Non-System Disk, Press Any Key" Then
it would boot and run fine. I fixed this error by repairing the Master Boot
Record (FixMBR) which led me to this issue. Now, ever time I shut down,
after windows saves all settings, I get a bluescreen, error stop code
00000050, Page_Fault_in_Nonpaged_Area.

Now I know this can be just about anything but I'm not running any different
hardware or software. That is why I wanted to give the history....
restoring from the Image, which was up to date.

Any other ideas?

"JCO" wrote in message
...
To give some history:
I got an error after doing a restoration of an Image created by Acronis
True Image. But the original error was: "Non-System Disk, Press Any Key"
Then it would boot and run fine. I fixed this error by repairing the
Master Boot Record (FixMBR) which led me to this issue. Now, ever time I
shut down, after windows saves all settings, I get a bluescreen, error
stop code 00000050, Page_Fault_in_Nonpaged_Area.

Now I know this can be just about anything but I'm not running any
different hardware or software. That is why I wanted to give the
history.... restoring from the Image, which was up to date.

Any other ideas?




If your original drive boots normally, then something went wrong in the
cloning.

If you get the same error with both drives, try running a RAM test

Okay, it was a bad image. I recovered from an earlier image and every thing
is okay.
Thanks

"philo" wrote in message
...

"JCO" wrote in message
...
To give some history:
I got an error after doing a restoration of an Image created by Acronis
True Image. But the original error was: "Non-System Disk, Press Any Key"
Then it would boot and run fine. I fixed this error by repairing the
Master Boot Record (FixMBR) which led me to this issue. Now, ever time I
shut down, after windows saves all settings, I get a bluescreen, error
stop code 00000050, Page_Fault_in_Nonpaged_Area.

Now I know this can be just about anything but I'm not running any
different hardware or software. That is why I wanted to give the
history.... restoring from the Image, which was up to date.

Any other ideas?




If your original drive boots normally, then something went wrong in the
cloning.

If you get the same error with both drives, try running a RAM test