|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 11th 05, 05:35 AM
|
|||
|
|||
Installation of SP2 Does Not Finish
During the installation of SP2 the install stops before it is finished. The
dialog box "Windows XP Service Pack 2 Setup Wizard" is open. The text "Finishing installation" is visible, the task bar indicates the install is about 50% complete, and in the Details box it says "Running processes after install." Task manager shows the install Wizard has a "Running" status. The system appears to be responsive. For example, the Start button still works. Any suggestions or comments are appreciated. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reinstalling IE6 on SP2 | Rohit Chhabra | Windows Service Pack 2 | 4 | February 8th 05 05:18 AM |
| Not "burning" to Cd after SP2 upgrade | \old\ devildog | Windows Service Pack 2 | 4 | December 2nd 04 05:33 PM |
| SP2 Boot failure, system freeze, AGPCPQ.SYS, AGP440.SYS lock-ups. | Trebor | Windows Service Pack 2 | 2 | October 19th 04 07:55 PM |
| XP SP2 and system restore? | jan nop | General XP issues or comments | 0 | September 11th 04 12:39 PM |
| SP 2 | Smiley | General XP issues or comments | 1 | September 10th 04 02:02 AM |
Threaded Mode