|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 19th 06, 02:16 PM
posted to microsoft.public.windowsxp.hardware
|
|||
|
|||
Connecting Palm pilot to desktop USB connection not recognised
I have just bought a Palm T/X palm pilot. When I first plugged in the device
with USB cable, computer message came up that there was unidentified hardware...I thought it was because hadn't yet installed the palm software. I installed palm software and was able to set it up and hotsync it once, but then with subseqent hotsyncs, the connection (through USB cable) with the desktop could not be established. I tried different ports with the same result? any advice?? 
|
| Ads |
|
#2
August 19th 06, 03:22 PM
posted to microsoft.public.windowsxp.hardware
|
|||
|
|||
|
Connecting Palm pilot to desktop USB connection not recognised
Uninstall all the Palm software and any reference in the USB
properties in Device manager for the Palm. Then, install the software after a reboot. Only when the software is installed, connect the USB device, in this case the Palm. "melliejean2" wrote in message ... |I have just bought a Palm T/X palm pilot. When I first plugged in the device | with USB cable, computer message came up that there was unidentified | hardware...I thought it was because hadn't yet installed the palm software. | I installed palm software and was able to set it up and hotsync it once, but | then with subseqent hotsyncs, the connection (through USB cable) with the | desktop could not be established. I tried different ports with the same | result? any advice??
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
