|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 5th 03, 01:20 PM
|
|||
|
|||
Voice and Video
Can not make voice and video work. Both locations using
Linksys BEFSR41 routers connected to broadband connections. UPnP is enabled on both the WinXP machines and in each router. Is there some kind of test site I can connect to verify each end is working properly? Wasn't there something like that for NetMeeting? 
|
| Ads |
|
#2
December 5th 03, 01:25 PM
|
|||
|
|||
|
Voice and Video
Eric;
Do both of you have the DMZ server open, example your machine is designated 192.168.1.100 DMZ should reflect that at both routers, (Linksys example) your machine and your friends. With MSIM 5.0 you then should be able to talk and if available, video...... BEfSR41 is UPNP enabled make sure you have the latest firmware installed. That should do it for you. Jack "Eric Williamson" wrote in message ... Can not make voice and video work. Both locations using Linksys BEFSR41 routers connected to broadband connections. UPnP is enabled on both the WinXP machines and in each router. Is there some kind of test site I can connect to verify each end is working properly? Wasn't there something like that for NetMeeting?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
