If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Is XP Pro built on NT technology?
Asking this as when I downloaded a prog to install a Packard Bell 1015 monitor driver for XP (see other post), it stated 'cannot run on NT' when I tried to run it. I have XP Pro. Any ideas?
BTW the file was Mondrvupd20.exe supposed to cover lots of PB drivers for all windows versions... ta |
Ads |
#2
|
|||
|
|||
"epicurus" wrote in message ... Asking this as when I downloaded a prog to install a Packard Bell 1015 monitor driver for XP (see other post), it stated 'cannot run on NT' when I tried to run it. I have XP Pro. Any ideas? BTW the file was Mondrvupd20.exe supposed to cover lots of PB drivers for all windows versions... ta -- epicurus Yes it is based on NT. |
#3
|
|||
|
|||
Yes it is.
"epicurus" wrote in message ... Asking this as when I downloaded a prog to install a Packard Bell 1015 monitor driver for XP (see other post), it stated 'cannot run on NT' when I tried to run it. I have XP Pro. Any ideas? BTW the file was Mondrvupd20.exe supposed to cover lots of PB drivers for all windows versions... ta -- epicurus |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reformat on custom built computer | Mike | Performance and Maintainance of XP | 3 | March 19th 05 01:58 AM |
Hyper-Threading Technology | alexus | General XP issues or comments | 3 | February 4th 05 02:49 PM |
Built in adapter disconnects automatically | Fermin Martin | Networking and the Internet with Windows XP | 0 | January 20th 05 03:21 PM |
BUILT IN USER ADMIN ACCOUNT | jaxguy9 | Security and Administration with Windows XP | 1 | August 19th 04 01:58 PM |
Burning DVD Stop Error | Neil | Hardware and Windows XP | 0 | July 27th 04 09:56 PM |