If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can't past from character map
I want to use some of the neat characters in character map but every
time I try all I get when I paste into my Microsoft Works word-processing document is a "?" or another type of character that I already have on my regular keyboard. I am following all the instructions for using the character map: I am selecting the character I want, then I copy it, and then I try to paste it...all to no avail. Is this a common problem? Any suggestions as to how to solve it? Thanks. |
Ads |
#2
|
|||
|
|||
Can't past from character map
|
#3
|
|||
|
|||
Can't past from character map
"Microbes@Work" wrote in message . ..
On 11 May 2003 17:58:28 -0700, (Shemp McGurk) wrote: I want to use some of the neat characters in character map but every time I try all I get when I paste into my Microsoft Works word-processing document is a "?" or another type of character that I already have on my regular keyboard. I am following all the instructions for using the character map: I am selecting the character I want, then I copy it, and then I try to paste it...all to no avail. Is this a common problem? Any suggestions as to how to solve it? Thanks. ½ is alt 0187 ? is alt 0128 © is alt 0169 I always find it easiest to use 'alt' + the numeric keypad. AC I even tried THAT and it didn't work...I pressed and held alt and then typed in the numbers and nothing appeared... |
Thread Tools | |
Display Modes | |
|
|