If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
help for DMA is needed
Thanks for the interest...
I take yor advice @;-) -----Original Message----- Hi, Try this way: Primary : Master - W.D harddisk Secondary: Master - Pioneer DVD Slave - Plextor CD/RW Make sure the jumper setting of your DVD rom and CD/RW are set correctly. Also check the BIOS setting for the IDE channels. Also go the the following website to download the latest ASPI drivers and utility for XP http://www.nu2.nu/aspi/ Peter -----Original Message----- My IDE channels configuratons is: Primary : Master Western Digital 80Gb HDD "Ultra DMA 5" Slave Pioneer DVD 117 16x/40x "PIO" Secondary :Master - Slave Plextor CDRW W1610A "Multi word DMA 2" For Primary IDE the cable has 80 lines and 40 pins I have Ms Windows XP Pro SP1 ------- The problem is that initially DMA was enabled in Pioneer but without doing anything (after several months)it turned to PIO. Even if I tried to selected "DMA if availiable" Windows doesnt change the acces mode to DMA --Is there anything wrong with ASPI? --Is there anything wrong with the CONFIGURATIONB of the channels --Is there any possible problem with the software I use NERO 5.5... ,PowerDVD XP ,CloneCD 4...? --Can I do smthn from BIOS (I have a cheap Elite mother board)? ----------------- Any help is more than acceptable @;-) . . |
Ads |
Thread Tools | |
Display Modes | |
|
|