If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"Module for MS Printing failed unexpectedly during initialization"
I have just installed Windows XP Home (over Windows 98SE).
When I attempted to install a printer (HP DJ 720) using the Add Printer Wizard, it all seems to work until I click on Finish. It then gives the message "Printer Driver was not installed. Operation could not be completed. After trying a few times I (finally) checked the setuperr.log to see if there were any problems with the upgrade - where I discovered the following message "Module for MS Printing failed unexpectedly during initialization" I have tried searching the knowledge base to no avail - does anyone have any suggestions on what I can do now ?? |
Ads |
#2
|
|||
|
|||
"Module for MS Printing failed unexpectedly during initialization"
If this was an upgrade installation, did you leave the printer connected
during the upgrade? If so the drivers may have become corrupted.... see the uninstall and reinstall instructions at http://www.coribright.com/Windows/Article%20One.htm When you come to reinstall, ensure you're logged on as an Administrator or User with Admin Rights. Cari www.coribright.com "Andrew Boundy" wrote in message ... I have just installed Windows XP Home (over Windows 98SE). When I attempted to install a printer (HP DJ 720) using the Add Printer Wizard, it all seems to work until I click on Finish. It then gives the message "Printer Driver was not installed. Operation could not be completed. After trying a few times I (finally) checked the setuperr.log to see if there were any problems with the upgrade - where I discovered the following message "Module for MS Printing failed unexpectedly during initialization" I have tried searching the knowledge base to no avail - does anyone have any suggestions on what I can do now ?? |
Thread Tools | |
Display Modes | |
|
|