If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HOW TO: Change the COM Port Number
I have a plotter/cutter that uses com port 8.
a program I need to use only goes to com port 7. I have XP and have tried to cange it in device manager but there isn't a place to do it. Help Thanks |
Ads |
#2
|
|||
|
|||
HOW TO: Change the COM Port Number
I tried a web search with the search term:
how to assign a COM port in Windows XP and found very many hits. I suggest you give it a try. --- Leonard Grey Errare humanum est Mike S. wrote: I have a plotter/cutter that uses com port 8. a program I need to use only goes to com port 7. I have XP and have tried to cange it in device manager but there isn't a place to do it. Help Thanks |
Thread Tools | |
Display Modes | |
|
|