|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 18th 07, 01:18 AM
posted to microsoft.public.windowsxp.print_fax
|
|||
|
|||
Hacking Pharos Print Station
I am trying to hack a print station that uses Pharos software (if not
familiar with it, it basically has you scan a card and deducts $ off the card and sends the job through to the printer). Previously I used to just get the IP address of the printer and print directly to this address vs. the default port that was set up which sent it through to the Pharos software and wait to be queued. For some reason, I can't get this to work anymore. When I send it to the printers IP the documents try to send but then I just get an error on the print status window. Did they figure me out and put up something to block this? How can I get around it? I don't think they're very smart so I'm sure I can get around it somehow... 
|
| Ads |
|
#2
September 21st 12, 10:02 PM
posted to microsoft.public.windowsxp.print_fax
|
|||
|
|||
|
Hacking Pharos Print Station
On Saturday, March 17, 2007 9:18:58 PM UTC-4, (unknown) wrote:
I am trying to hack a print station that uses Pharos software (if not familiar with it, it basically has you scan a card and deducts $ off the card and sends the job through to the printer). Previously I used to just get the IP address of the printer and print directly to this address vs. the default port that was set up which sent it through to the Pharos software and wait to be queued. For some reason, I can't get this to work anymore. When I send it to the printers IP the documents try to send but then I just get an error on the print status window. Did they figure me out and put up something to block this? How can I get around it? I don't think they're very smart so I'm sure I can get around it somehow... have there been any solutions??
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
