If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
error message 0x00000000 reference memory could not be after Windo
I get an error message about reference memory just after WindowsXP loads up
(SP3). Here is a link to a picture of the exact error message: http://picasaweb.google.com/bberks/W...52454729280098 If I click "OK" or "CANCEL" I can only open 1 program at which it then locks up (does not matter what program). If I don't click "OK" or "CANCEL" I can open any program just fine so long as the error window stays open. I have run a CHKDSK, SPINRITE and DEFRAG without any change or improvement. What should I do to get rid of this error message? I really really don't want to have to re-install my system.( |
Thread Tools | |
Display Modes | |
|
|