If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
SP2 Firewall Exceptions
Hi, everyone:
Does anyone know of a way to get Windows Firewall to allow access on all ports to a specified IP address or subnet? I ask because I can allow specific ports, but wildcards like "*" don't seem to work. Ideally, this would be done through group policy, but any means necessary would be a good start. Any thoughts out there? -- Steve Athanas Systems Analyst / Administrator UMass Lowell Student Affairs Cumnock Hall 1 University Ave. Lowell, MA 01854 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
RPC Connection problems with XP Firewall, dispite proper exeptions | Robert | Security and Administration with Windows XP | 0 | January 31st 05 02:42 PM |
xp sp2 | Jagdish Chandra | Windows Service Pack 2 | 4 | December 13th 04 09:33 AM |
Best way to install SP2 ?? which is ?? | Avid Gamer | Windows Service Pack 2 | 8 | September 25th 04 08:58 PM |
SP2 - Cable Connection | Leadfootlady | Windows Service Pack 2 | 5 | September 16th 04 02:26 AM |
Turing of SP2 Firewall via registry entry? | Sean B | Windows Service Pack 2 | 10 | August 29th 04 03:29 AM |