|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 17th 08, 01:26 AM
posted to microsoft.public.windowsxp.newusers
|
|||
|
|||
missing two r/w cd hardware devices that were pre assigned earlier
Hello;
I went to look at what I had done so far and I noticed an error specifying missing hardware devices but the drivers for those locations appeared ok. (drive's b: & c  . besides doing a total restore is there any way to reinsert those two missing hardware icons back so I can use them ? thank you -- mrtigre 
|
|
#2
May 17th 08, 03:07 AM
posted to microsoft.public.windowsxp.newusers
|
|||
|
|||
|
missing two r/w cd hardware devices that were pre assigned earlier
-- mrtigre "ragsy" wrote: Hello; I went to look at what I had done so far and I noticed an error specifying missing hardware devices but the drivers for those locations appeared ok. (drive's b: & c . besides doing a total restore is there any way to reinsert those two missing hardware icons back so I can use them ? thank you -- mrtigre
|
|
#3
May 17th 08, 03:14 AM
posted to microsoft.public.windowsxp.newusers
|
|||
|
|||
|
missing two r/w cd hardware devices that were pre assigned earlier
the help you have giving me so far has been great. However I was only able
to get one cd drive converted. I still need drive E: do I need to run this for each drive I need converted? the error message was that it couldn't find that particular physical drive name. I will continue tommorrow with this thanks for all your halp I will close up on this then. if you have time just leave me a note and tell me what I can to to correct my ways or do at this point.? thank you much--Don-- mrtigre "ragsy" wrote: Hello; I went to look at what I had done so far and I noticed an error specifying missing hardware devices but the drivers for those locations appeared ok. (drive's b: & c . besides doing a total restore is there any way to reinsert those two missing hardware icons back so I can use them ? thank you -- mrtigre
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
