If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
truecrypt
I want f.hc to always open in the F: drive when I click on f.hc and to
always go to the G: drive when I click on g.hc and always go to the H: drive when I click on h.hc, etcetera. When I click on a truecrypt "container" file it opens up the gui. The drive letter is not selected until I pick it out of the list. It is efficient but I want to eliminate that one drive selection step. That is because I always open drives in the same letter all the time. All I want is to always open to the same drive letter. But how? |
Thread Tools | |
Display Modes | Rate This Thread |
|
|