Trouble installing on Intel D865PERL mb

Hi,

Restart setup. As soon ans it says "Installing Devices"
hit shift and F10 at the same time(Do not do this step
until it says installing devices). This will produce a DOS
prompt. In the DOS prompt type in taskmgr and hit enter.
This will open TaskManager. In taskmanager, go to the
processes tab and end all svchosts processes.
Once you do this exit taskmanager and close the dos prompt.
(You will have to be quick with the steps above).

Now the fun begins. IT will prompt you to install each
piece of hardware on the machine. Say yes to all until you
get to the one that reboots the machine. Make a note of
which one rebooted the machine.
Now do the steps mentioned above again. Restart setup and
such.
Now when you get to the one that reboots the machine say
NO to install it. This will get you by it but you will
have to deal with it once you get windows back up and
running. Most likely a chip or an onboard device giving
you the trouble.
-----Original Message-----
Trying to perform a "repair" install after replacing
MB/CPU/Memory. During
Installing Windows phase (Installing Devices) about 2/3
way through the
screen goes blank for a moment then comes back. Then
after another couple of
minutes the system reboots - only to restart the install
and repeat the
scenario (rebooting).
I just picked up the latest BIOS for this board the
problem is still
happening
..
MB Intel D865PERL
CPU: P4 2.60C (supports hyper threading)
Memory: pair of PNY 512 MB 2700

Anyone else using this board with WinXP?

Wes


.