If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
understanding network wizard
I have a basic knowledge of setting up a LAN but still would like to know more.
What I normally do to setup a LAN: 1)get all computers on same workgroup 2)enable file & printer sharing for microsoft networks (network adapter properties) 3)set IP & DNS to obtain addresses automatically 4)enable sharing on specific folders that I want shared 5)enable remote assistance (only if desired since high risk) When I share a folder for the first time on any of the computers -- a shared documents properties window appears saying that for security reasons remote access is disabled. If I want to enable this feature I should run the network setup wizard. I'd like to know exactly what else this wizard is doing that I haven't already done? How would I navigate to manually enable this feature? |
Ads |
Thread Tools | |
Display Modes | |
|
|