If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Maxstore 160GB HDD Unreadable in a Dell
My daughter's HDD on her Dell Dimension PC crashed and became unreadable
(not backed up of course) - unbootable volume reported. The Windows XP setup disk could see 3 partitions (2 Dell diagnostic partitions FAT and FAT32) plus and unknown one (main NTFS partition) - I have not reformatted or done anything to the disk since. I installed a new drive and set up the PC and put the faulty one in as HDD 2 but CHKDSK found loads of unreadable consecutive blocks but did also report it's percentage complete so was reading some blocks. My local PC "expert" shop had a go and got nowhere saying it was a disk hardware problem - they did nothing. Reading various data recovery websites, claims are made for using their tools in such cases. Is there any point in trying further when CHKDSK reports unreadable (not just corrupt) blocks. Are there any good tools available on the market that could be tried at reasonable cost. What about File Scavenger or instance. Any suggestions appreciated Graham Brooker |
Ads |
#2
|
|||
|
|||
Maxstore 160GB HDD Unreadable in a Dell
So wait, the new drive is 160GB and it's being reported as unreadable? If
that is the case, if it's an older unit it's entirely likely that the BIOS won't be able to read volumes of that capacity. Meanwhile, bad blocks on a hard disk indicate that the read/write heads are having issues accessing the physical sectors on the platters. Unfortunately, there is no software program that can fix that. In fact, when you run chkdsk /r it doesn't fix bad sectors - it locks them down and tries to move the data stored on them to known working sectors. Data recovery programs usually can only recover data on a drive that's been formatted but is still in working condition... so I'd avoid spending money on them. "Graham Brooker" wrote: My daughter's HDD on her Dell Dimension PC crashed and became unreadable (not backed up of course) - unbootable volume reported. The Windows XP setup disk could see 3 partitions (2 Dell diagnostic partitions FAT and FAT32) plus and unknown one (main NTFS partition) - I have not reformatted or done anything to the disk since. I installed a new drive and set up the PC and put the faulty one in as HDD 2 but CHKDSK found loads of unreadable consecutive blocks but did also report it's percentage complete so was reading some blocks. My local PC "expert" shop had a go and got nowhere saying it was a disk hardware problem - they did nothing. Reading various data recovery websites, claims are made for using their tools in such cases. Is there any point in trying further when CHKDSK reports unreadable (not just corrupt) blocks. Are there any good tools available on the market that could be tried at reasonable cost. What about File Scavenger or instance. Any suggestions appreciated Graham Brooker |
#3
|
|||
|
|||
Maxstore 160GB HDD Unreadable in a Dell
"Jack" wrote in message
... Data recovery programs usually can only recover data on a drive that's been formatted but is still in working condition... so I'd avoid spending money on them. Thanks Jack for your explanation. I decided to have a go and download the free trial version of File Scavenger 3.0 to see if it could do anything. It worked very well and reported good status on all the files I needed. I paid the $57 registration fee and successfully recovered everything onto a new HDD. It seems that s/w was able to skip the bad sectors and go straight to the bits that worked that still had my data intact. In this instance it was worthwhile especially as you could look and see for free. Graham |
Thread Tools | |
Display Modes | |
|
|