|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 13th 06, 10:44 AM
posted to microsoft.public.windowsxp.hardware
|
|||
|
|||
unable to enable wireless network adapter
I recently installed a us robotics network adapter into my desktop, but when
I try to connect to the internet it states that although the adapter is enabled the hardware switch needs to be enabled before the adapter will work. Can someone please tell me how to enable the hardware switch on a desktop. Thanks 
|
| Ads |
|
#2
September 13th 06, 08:55 PM
posted to microsoft.public.windowsxp.hardware
|
|||
|
|||
|
unable to enable wireless network adapter
"Corrissa" wrote:
I recently installed a us robotics network adapter into my desktop, but when I try to connect to the internet it states that although the adapter is enabled the hardware switch needs to be enabled before the adapter will work. Can someone please tell me how to enable the hardware switch on a desktop. Basically this message says that somewhere on the adapter is a hardware switch (button, jumper or whatever) and you should turn it ON. If your model does not have this switch or you can't locate it, call the USR support. Regards, --PA
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
