If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
removing "GoBack" from mbr
I cant access my 40g hd because of an error involving
Roxio's GoBack. I forgot to disable it before trying to upgrade to a 250g hd. I messed that part up so I wanted to back out and start again. When I rebooted the 40g it made it to the inital winxp screen before it gave me an autochk program not found. THen a flash message about some kind of fatal error, then it tries to reboot over and over. I tried recovery console, but it tells me I have a dynamic drive and am I sure I was to "fixmbr?" Im afraid that will be a point of no return so I didn't know if I should try it. I tried the manual removal of goback using the solution listed in knowledge base (ctl+alt+G), but that didn't seem to work either. Any ideas? |
Ads |
Thread Tools | |
Display Modes | |
|
|