If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
understanding network wizard
I have a basic understanding of setting up a home LAN using a router:
1) set all computers on the same workgroup 2)enable file & printer sharing for microsoft networks 3)set each computer to obtain IP & DNS automatically 4)enable sharing on folders that I desire 5)enable remote assistance (only if desired since high security risk) When I do step#4 for the first time on any computer I get a "shared documents properties" window that opens that says windows has disabled remote access as a security measure. If I wish to enable it then I should run Network Setup Wizard. What would this wizard do that I haven't already done? How would I navigate to the appropriate areas to manually enable it? |
Ads |
Thread Tools | |
Display Modes | |
|
|