|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 4th 04, 06:30 AM
|
|||
|
|||
IPSEC not working
I have XP with SP2. I created a policy to connect to a VPN.
When I tried to assign it says... "The service cannot be started, either because it is disabled or because it has no enabled devices associated with it. (80070422)" I see the 
|
| Ads |
|
#2
December 8th 04, 05:40 PM
|
|||
|
|||
|
IPSEC not working
Check to see if the IPSec service is running.
Go to Start, Settings, Control Panel, Administraotr tools and open Services. in the new window that pops up find IPSEC Services, open it and see if Startup type is set to Automatic, if not then set it. Next see if it is started by looking next to Service status: if it is not started then click on the start button. No try and use IPSec and see if you get the error.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Keyboard not working | Gus | General XP issues or comments | 3 | November 18th 04 07:54 PM |
| TCP/IP (send) stopped working (Receive works) | KeithP | Networking and the Internet with Windows XP | 2 | October 27th 04 03:53 PM |
| IPSec Services | Keith | Security and Administration with Windows XP | 4 | August 21st 04 11:31 AM |
| System Standby on my thinkpad stopped working | Tal Moore | General XP issues or comments | 0 | August 3rd 04 06:59 AM |
Linear Mode
