If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
'Safely Remove Hardware' Problem
Apologies but a quick note, further to my previous post.
There are two further details that may be of use: 1) The same issue occurs with a PCMCIA wireless adapter I use; the 'Safely Remove Hardware' facility problem is as previously described and, occassionally, disabling it can fail whereby selecting 'Disable' will not get a response but the card will stop responding and it will not be possible to re-enable it; even by physically removing and replacing it. 2) It is difficult to say with any certainty but I think that it these problems only occur after the computer has been put into and taken out of hibernation. I hope someone can assist me with this issue. Thank you again, -- Karim434 |
Ads |
Thread Tools | |
Display Modes | |
|
|