If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Using ImageX to image 2 volumes
I am deploying a system with 2 volumes (a C: and a D: drive) and I want to
use imageX to back up the system to a .WIM file. How do I tell imageX to image both volumes into a single .WIM file? Also when I go to "restore" the image, or deploy the image, how do I get imageX to restore to both volumes with minimal effort? Do I need to create these volumes on the host PC manually or will imageX do this for me with the /apply switch? Thanks Russell |
Ads |
Thread Tools | |
Display Modes | |
|
|