If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
File and printer sharing
We have four Windows XP Pro SP2 machines connected on a LAN. They all are
auto-logged on with identical user credentials. There are a couple of printers attached to one of them. These printers have sharing enabled and security settings set to allow everyone full control. While the other three machines can see the printers on the fourth, they cannot 'connect' to it when the add-printer procedure is run. They are also not automatically discovered at log on. All machines had the network wizard run to make sure that workgroup name was identical and file and printer sharing was turned on. Also, the PC with the printers attached has a folder set to be shareable by everyone with full control. This too can be 'seen' by the other machines but we get a 'not-permitted' error when accessis tried. We would also like the printer and file sharing to work when other users are logged on the machines. BTW, all four machines are connected through a switch that is fed by a DSL router. There is no Internet access problem with any. Any help in resolving this issue would be gratefully appreciated. Regards and TIA. Mobius -------- |
Ads |
#2
|
|||
|
|||
File and printer sharing
Are all "identical user credentials" using the same password and no blank
password? -- Bob Lin, MS-MVP, MCSE & CNE Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com "Mobius" wrote in message ... We have four Windows XP Pro SP2 machines connected on a LAN. They all are auto-logged on with identical user credentials. There are a couple of printers attached to one of them. These printers have sharing enabled and security settings set to allow everyone full control. While the other three machines can see the printers on the fourth, they cannot 'connect' to it when the add-printer procedure is run. They are also not automatically discovered at log on. All machines had the network wizard run to make sure that workgroup name was identical and file and printer sharing was turned on. Also, the PC with the printers attached has a folder set to be shareable by everyone with full control. This too can be 'seen' by the other machines but we get a 'not-permitted' error when accessis tried. We would also like the printer and file sharing to work when other users are logged on the machines. BTW, all four machines are connected through a switch that is fed by a DSL router. There is no Internet access problem with any. Any help in resolving this issue would be gratefully appreciated. Regards and TIA. Mobius -------- |
#3
|
|||
|
|||
File and printer sharing
Are all "identical user credentials" using the same password and no blank
password? -- Bob Lin, MS-MVP, MCSE & CNE Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com "Mobius" wrote in message ... We have four Windows XP Pro SP2 machines connected on a LAN. They all are auto-logged on with identical user credentials. There are a couple of printers attached to one of them. These printers have sharing enabled and security settings set to allow everyone full control. While the other three machines can see the printers on the fourth, they cannot 'connect' to it when the add-printer procedure is run. They are also not automatically discovered at log on. All machines had the network wizard run to make sure that workgroup name was identical and file and printer sharing was turned on. Also, the PC with the printers attached has a folder set to be shareable by everyone with full control. This too can be 'seen' by the other machines but we get a 'not-permitted' error when accessis tried. We would also like the printer and file sharing to work when other users are logged on the machines. BTW, all four machines are connected through a switch that is fed by a DSL router. There is no Internet access problem with any. Any help in resolving this issue would be gratefully appreciated. Regards and TIA. Mobius -------- |
#4
|
|||
|
|||
File and printer sharing
"Robert L. (MS-MVP)" wrote in message
... Are all "identical user credentials" using the same password and no blank password? Yes. It is the same password. -- Bob Lin, MS-MVP, MCSE & CNE Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com "Mobius" wrote in message ... We have four Windows XP Pro SP2 machines connected on a LAN. They all are auto-logged on with identical user credentials. There are a couple of printers attached to one of them. These printers have sharing enabled and security settings set to allow everyone full control. While the other three machines can see the printers on the fourth, they cannot 'connect' to it when the add-printer procedure is run. They are also not automatically discovered at log on. All machines had the network wizard run to make sure that workgroup name was identical and file and printer sharing was turned on. Also, the PC with the printers attached has a folder set to be shareable by everyone with full control. This too can be 'seen' by the other machines but we get a 'not-permitted' error when accessis tried. We would also like the printer and file sharing to work when other users are logged on the machines. BTW, all four machines are connected through a switch that is fed by a DSL router. There is no Internet access problem with any. Any help in resolving this issue would be gratefully appreciated. Regards and TIA. Mobius -------- |
#5
|
|||
|
|||
File and printer sharing
"Robert L. (MS-MVP)" wrote in message
... Are all "identical user credentials" using the same password and no blank password? Yes. It is the same password. -- Bob Lin, MS-MVP, MCSE & CNE Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com "Mobius" wrote in message ... We have four Windows XP Pro SP2 machines connected on a LAN. They all are auto-logged on with identical user credentials. There are a couple of printers attached to one of them. These printers have sharing enabled and security settings set to allow everyone full control. While the other three machines can see the printers on the fourth, they cannot 'connect' to it when the add-printer procedure is run. They are also not automatically discovered at log on. All machines had the network wizard run to make sure that workgroup name was identical and file and printer sharing was turned on. Also, the PC with the printers attached has a folder set to be shareable by everyone with full control. This too can be 'seen' by the other machines but we get a 'not-permitted' error when accessis tried. We would also like the printer and file sharing to work when other users are logged on the machines. BTW, all four machines are connected through a switch that is fed by a DSL router. There is no Internet access problem with any. Any help in resolving this issue would be gratefully appreciated. Regards and TIA. Mobius -------- |
Thread Tools | |
Display Modes | |
|
|