If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
problem with printers
I just purchased a new Hp Photosmart 7150 and I cannot
get it to print anything. It installs successfully, it is recognized by the system properly and the system seems to think it is working just fine. But nothing happens-- the document appears in the queue but then is automatically deleted. Prior to purchasing this printer, I recall beginning to have problems with the printer I was using over the LAN--I figured it was a networking issue. The same glitch occurs with this new printer as began to occur with the other: when I try to open the printer preferences, the window appears for just a fraction of a second and then disappears again. I'm figuring this has something to do with my problem, as I have followed all available troubleshooting procedures for the printer. I'm wondering what might be going on from my end? Any suggestions? |
Ads |
#2
|
|||
|
|||
problem with printers
Before you installed it locally, did you uninstall it over the LAN?
Is the default printer set to be the local one or are you still trying to print over the LAN (to a print that might not be there anymore!) Try one more total uninstall and reinstall using: http://www.coribright.com/Windows/Article%20One.htm Cari www.coribright.com "Robert" wrote in message ... I just purchased a new Hp Photosmart 7150 and I cannot get it to print anything. It installs successfully, it is recognized by the system properly and the system seems to think it is working just fine. But nothing happens-- the document appears in the queue but then is automatically deleted. Prior to purchasing this printer, I recall beginning to have problems with the printer I was using over the LAN--I figured it was a networking issue. The same glitch occurs with this new printer as began to occur with the other: when I try to open the printer preferences, the window appears for just a fraction of a second and then disappears again. I'm figuring this has something to do with my problem, as I have followed all available troubleshooting procedures for the printer. I'm wondering what might be going on from my end? Any suggestions? |
Thread Tools | |
Display Modes | |
|
|