If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"net use"
How does one END a "net use" command? Plenty of
instructions on how to set it up....THANKS! |
Ads |
#2
|
|||
|
|||
"net use"
I assume you mean how to remove the mapping created by the net use command.
net use device /d e.g. net use lpt1: /d If the original net use command is issued without the /persistent:yes parameter, the mapping is automatically deleted when the user logs off. -- Bruce Sanderson MVP It's perfectly useless to know the right answer to the wrong question. "Eric G" wrote in message ... How does one END a "net use" command? Plenty of instructions on how to set it up....THANKS! |
#3
|
|||
|
|||
"net use"
Thanks a Million!!! That was the right answer!!! I owe
you 1! -----Original Message----- I assume you mean how to remove the mapping created by the net use command. net use device /d e.g. net use lpt1: /d If the original net use command is issued without the /persistent:yes parameter, the mapping is automatically deleted when the user logs off. -- Bruce Sanderson MVP It's perfectly useless to know the right answer to the wrong question. "Eric G" wrote in message ... How does one END a "net use" command? Plenty of instructions on how to set it up....THANKS! . |
Thread Tools | |
Display Modes | |
|
|