If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DOS program print to USB port
I have an old DOS based program that only recognizes an
LPT port and I want to print using a USB printer on the local machine. How do I use the "netuse" command to "map" a USB printer so that the DOS program recognizes it as printing to LPT1? I will need syntax and location of the command. Thank you! rick |
Ads |
#2
|
|||
|
|||
DOS program print to USB port
See Bruce Sanderson's instructions at
http://members.shaw.ca/bsanders/printfromdos.htm -- Cari MS-MVP Windows Technologies - Printing/Imaging/Hardware www.coribright.com "Rick" wrote in message ... I have an old DOS based program that only recognizes an LPT port and I want to print using a USB printer on the local machine. How do I use the "netuse" command to "map" a USB printer so that the DOS program recognizes it as printing to LPT1? I will need syntax and location of the command. Thank you! rick |
Thread Tools | |
Display Modes | |
|
|