If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Need Performance: Best Use of SATA Drive?
I bought a SATA drive yesterday to get my paging file off the system disk.
ASSUMING there is a 15-20% increase in disk through put, would I gain more by mocing my system disk to the SATA and using the IDE for paging? |
Ads |
#2
|
|||
|
|||
Need Performance: Best Use of SATA Drive?
It probably makes no difference. Put both on fastest drive. But see what photoshop wants.
For windows none of it makes a significant difference. For photoshop who knows. Ask in PS groups. -- -------------------------------------------------------------------------------------------------- Read David defending the concept of violence. http://margokingston.typepad.com/har...e_ga.html#more ================================================= "Largelylivin" wrote in message ... I bought a SATA drive yesterday to get my paging file off the system disk. ASSUMING there is a 15-20% increase in disk through put, would I gain more by mocing my system disk to the SATA and using the IDE for paging? |
#3
|
|||
|
|||
Need Performance: Best Use of SATA Drive?
"Largelylivin" wrote in message ... I bought a SATA drive yesterday to get my paging file off the system disk. ASSUMING there is a 15-20% increase in disk through put, would I gain more by mocing my system disk to the SATA and using the IDE for paging? Unless you bought a 10,000 rpm SATA, there is very little difference between IDE and SATA. Jim |
#4
|
|||
|
|||
Need Performance: Best Use of SATA Drive?
My existing system disk is a Seagate ST380021A 80G. Its never performed well
in comparison to a couple WDs that I have. Its avg read is 36MB/s and bursts at 74MB/s. The Maxtor SATA test results (from the web) show avg read of 49 MBs and a burst speed of 111 Mbs. That is a good improvement over my current disk. "Gerry Cornell" wrote: Jim Doesn't that depend on their respective read / write speeds? The IDE disk could be old or not so old etc. ~~~~~~ Gerry "Jim" wrote in message . com... "Largelylivin" wrote in message ... I bought a SATA drive yesterday to get my paging file off the system disk. ASSUMING there is a 15-20% increase in disk through put, would I gain more by mocing my system disk to the SATA and using the IDE for paging? Unless you bought a 10,000 rpm SATA, there is very little difference between IDE and SATA. Jim |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
eSATA support | Techmanblues | Hardware and Windows XP | 9 | December 9th 05 03:05 AM |
Making a SATA drive the boot drive | BobV | Hardware and Windows XP | 39 | June 12th 05 03:20 PM |
Adding a second hard drive problem | kimmo | Hardware and Windows XP | 14 | March 19th 05 02:13 PM |
no operating system upon boot | Zattack | The Basics | 15 | November 5th 04 02:46 PM |
Hot Swapping a SATA drive in Windows 2000 and XP. | Chris S | Hardware and Windows XP | 26 | September 12th 04 12:39 AM |