If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Model: WD5000AADS
http://www.wdc.com/en/products/products.asp?driveid ... I bought a new hard
drive and installed it properly to the best of my abilities and probably installed it correctly. The first thing I did when installing Windows XP was format the hard drive but Windows stopped installing and gave a message something like, Windows can not finish the install. Is there a type of problem associated with this error message. I attempted to install XP again and began the format as before and the installation skipped that part of install and continued to install and finished ok. Later after a completed install with drivers and SP3 there is ometimes an error message, firmware indicates(or similar)detected cmos battery failure. I installed a new cmos battery , matsushima brand, and the message still appears during start. A reboot loads Windows ok. Hi. -- ....scribble scribble scribble... |
Ads |
Thread Tools | |
Display Modes | |
|
|