|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 12th 10, 12:26 PM
posted to microsoft.public.windowsxp.general,microsoft.public.windowsxp.help_and_support,microsoft.public.windowsxp.hardware,comp.sys.ibm.pc.hardware.storage
|
|||
|
|||
Can write onto a DVD but not read from DVD: "The device is not ready"
After having worked successfully for a couple of years with my current DVD drive (recorder)
there are now problems since a few days. I can write (=burn) as usually onto a DVD. But when I want to read the content of such a DVD nothing is listed. The drive letter is shown as usual in WinExplorer. When I click on it the DVD seems to be empty. Nothing is shown. dir E: in Command prompt shows permanently "The device is not ready" even after 30 minutes! When I insert the same DVD in another computer (with WinXP) then the 4 files are shown without problems. So whats wrong? Is it a driver a WinXP settings problem? Again: Burning is possible Cindy 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
