|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 4th 05, 06:29 PM
|
|||
|
|||
No USB ports after SP2
On Emachine T2792, lost all USB ports after SP2. Uninstall SP2 and all work.
I have (after SP2 is installed) deleted all from Device Manager and let Windows find them again (root hub, et al) and used "Update Driver" from each one. No devices are recogized any more. 
|
| Ads |
|
#2
August 5th 05, 03:54 AM
|
|||
|
|||
|
I think you just need to find the folder where the usb drivers are and update
to that folder instead of letting windows install them... j;-) "Jaime" wrote: On Emachine T2792, lost all USB ports after SP2. Uninstall SP2 and all work. I have (after SP2 is installed) deleted all from Device Manager and let Windows find them again (root hub, et al) and used "Update Driver" from each one. No devices are recogized any more.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem about Window Xp SP2 firewall and the buildin FTP command | ping | Windows Service Pack 2 | 2 | June 23rd 05 02:47 PM |
| USB Hub Device Drivers Not found on Windows XP SP2 system with USB ports connected. | Richard | Windows Service Pack 2 | 2 | June 10th 05 08:33 PM |
| Not "burning" to Cd after SP2 upgrade | \old\ devildog | Windows Service Pack 2 | 4 | December 2nd 04 05:33 PM |
| SP2 Boot failure, system freeze, AGPCPQ.SYS, AGP440.SYS lock-ups. | Trebor | Windows XP Help and Support | 0 | October 19th 04 07:35 PM |
| USB ports not working after SP2 - fixes not helping | Dan | Windows Service Pack 2 | 3 | September 21st 04 06:19 AM |
Linear Mode
